Flow Rate CalculatorLiquid, gas & engineering tools

Flow rate calculators / Pipe hydraulics

Measure flow. Understand the conditions.

Pressure & Head Calculator

Convert a pressure difference to equivalent fluid head for a specified density.

Your flow inputs

kPa
kg/m³

Starting values are illustrative. Check units and assumptions below. Calculate submits your inputs to this site’s result page.

Reset

Your result

Ready to calculate

Enter your values and press Calculate. The result will open on the calculation page.

Published references · Clear assumptions · No sign-up

The method

Formula and calculation steps

Pressure head metres = pressure difference Pa / (density × g).

Convert a pressure difference to equivalent fluid head for a specified density.

  1. Choose a measurement plane and use compatible units for all inputs.
  2. Obtain appropriate product data or representative measurements for the stated model.
  3. Submit the form, then interpret the result with the assumptions and limits below.

A head difference does not determine flow without a resistance or device relationship.

Pressure & Head calculation: inputs and interpretation

A metre of head is an energy-per-weight representation, not a universal pressure unit independent of fluid. The same pressure difference corresponds to more metres of head for a lower-density fluid. Gauge versus absolute reference cancels only when a consistent pressure difference is used.

Pipe losses depend on the model and fluid condition. Inner diameter, roughness, temperature-dependent properties and fittings must be consistent. A result for one straight run does not solve a branched network, select a pressure rating or establish a safe maximum operating flow.

Check the numbers

Pressure & Head Calculator: calculated examples

These are computed scenarios using the same server calculation as the form. They are not manufacturer ratings or prescribed design values.

Worked example with stated inputs

Pressure difference = 100 kPa; Fluid density = 998 kg/m³.

OutputComputed result
Equivalent fluid pressure head10.217597 m
Pressure difference14.503774 psi

How one input changes the answer

ScenarioChanged inputResult
25 kPaPressure difference2.554399 m
50 kPaPressure difference5.108799 m
75 kPaPressure difference7.663198 m
100 kPaPressure difference10.217597 m
150 kPaPressure difference15.326396 m
200 kPaPressure difference20.435195 m
300 kPaPressure difference30.652792 m

Unchanged inputs use: Pressure difference = 100 kPa; Fluid density = 998 kg/m³. Results retain the model limitations described above.

Common questions

Can I convert bar to flow rate here?

No. This converts pressure to head, not pressure to volume/time.

Is metres of water the same as metres of any fluid?

No. Density connects head and pressure.

Does this include elevation automatically?

It reports equivalent pressure head only; total energy head can include elevation and velocity terms.

What g is used?

The calculations use standard gravity 9.80665 m/s² as a stated conversion/model convention.

Which assumptions should I verify?

Check every unit, the observation period and the physical or reference-state boundary stated above. Starting inputs and computed examples are illustrative scenarios, not recommended settings, certified capacities or universal standards.

Where are the formula sources?

Published method and unit references appear at the bottom of this page as plain-text addresses. Computed tables use the same server calculation as the form. No external content-data file is needed at runtime.

Formula sources and references

References support the underlying methods and units. Chosen example inputs are not universal recommendations, current tariffs or proprietary test results.

  • US DOE Fundamentals Handbook, Thermodynamics, Heat Transfer and Fluid Flow, Volume 3https://www.energy.gov/sites/default/files/2026-04/DOE-HDBK-1012-92_VOL3.pdf
  • NIST SP 811 Appendix B.9: volume, mass and flow unit factorshttps://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9